Pallet rack weight capacity isn't one number, it's three: beam capacity, upright capacity, and bay capacity, and the lowest of the three is what your rack actually holds. A beam pair rated at 5,000 pounds carries that load across both beams on the level, not per beam,...

New domestic pallet racking takes about 14 weeks to reach your dock, and in the last equipment crunch that stretched to 18 or 20. Used warehouse equipment cuts the wait to days, because the steel already exists and skips mill lead times, fabrication backlogs, and...

Every rack in our inventory is inspected, quality-graded, and ready to ship. You get structural steel at a fraction of the cost of new, with the same load ratings and the same performance. No waiting on factory lead times. No compromising on quality.Tell us your floor...

Efficient warehouse layout design starts with product flow, not rack placement. Map how goods move from receiving to storage to pick to shipping, then set aisles, slotting, and racking around that path. Most floors slow down because the layout gets treated like...

Steel tariffs have pushed new warehouse equipment prices 15 to 22% higher, which is why more buyers are pricing used racking this year. Section 232 duties doubled from 25% to 50% in June 2025, and hot rolled coil reached $1,002 per ton by March 2026 against $694 at...

Damaged pallet racking gets replaced, not straightened. Once a steel upright bends, the metal has yielded, and pulling it back with a pry bar doesn't restore the load rating it shipped with. OSHA has no racking-specific standard, so inspectors fall back on the General...

Used pallet racking costs roughly half to a third of new. A used upright frame runs about $40 to $80 against $120 to $180 new, and used beams sit near $15 to $30 where new equivalents cost double or triple. Across a 50-frame, 300-beam system that's $9,000 to $13,000...

Cantilever racking holds long, awkward loads like pipe, lumber, and steel tube that pallet rack can't support, using arms that extend from a vertical column with no front post blocking the load. Choosing a system comes down to three calls: load rating per arm, arm...

Used cantilever racks ship into New Jersey same-week from A&A Surplus in Plantsville, CT, roughly two hours from the state's main distribution corridors, and they cost far less than new stock that takes 10 weeks or more to build. New Jersey carries about 1.02...